If you own or want to buy the IKEA MALM nightstand, but not the MALM headboard which included bonding hardware, it may be at a loss for how to assemble this unusual driving style nightstand. Place the large sheet of paper around the back of the bedside nightstand, the location of the screw holes. Now you have a screw hole template. Cut from two sections of plywood which 19 inches x 3 inches. Cut and one long side on both of the plywood strips to an angle of 45 degrees. Ensure together the two sectional that they properly interlock dry-fit.
Find a horizontal stud with your stud finder where you can add the MALM to your wall. One of the plywood lengths on the wall here, directly to the stud below, with 3-inch wood screws; Add place the bevel and the upper edge of the sloping area facing the wall. The length of the multiplex must be exactly horizontal, so check it with your level before you screw it to the wall. Fasten which plywood length on the back of the MALM nightstand, with the help of the nightstand, the factory-drilled holes and one half-inch wood screws. Mount the nightstand to the wall by increasing the back side of the nightstand.