Indoor Wall Sconces– The installation of a wall light is a very simple DIY and that allows to change the decoration and atmosphere of a room completely at all. Whether you install a downlight, lights or any other light, this is part of the work accessible and fairly inexpensive. Before anything else, it is imperative to cut off electricity from the room in question. Go to the electrical panel and disconnect the fuse.
I start by removing the wall to recover the support and bring out the wires. After turning off the power, I cut the indoor wall sconceswires to the correct length using the cutting pliers. I stripped the 3 threads about 1 centimeter either with a wire stripper or with a Leatherman type knife. I position the support on the wall and I mark the locations of future pegs with a pencil. I make 2 holes in the place using the drill with the drill corresponding to the diameter of the ankle.
I place the support over the dowels, I install the screws (adjust the torque of the screwdriver to avoid damaging the support). Personally, I always do the last quarter turn by hand with a screwdriver. I place the wires in the domino of the indoor wall sconces, respecting the color code. You have to use a small flat screwdriver and then close the case. It remains for me to fix the wall on the support previously installed on the wall.